fitting LT switch

[no1bladesfan]

Hi, I cant find a tutorial on fitting the LT switch. i basicly follow Cofree vid on the mra doing the cuts, then fix the LT switch to the board soldering to the board on the holes, then get a dump and flash right. would i be correct in saying this? If by any chance i missed the video could you reply with the link i would appreciate this. thanks guys, keep up the great work you doing here.

[gazzer]

just write fitting lt switch to 360 drive you tube. in your browser should get lots of vids on the subject

[HaGGardSmurf]

To fit it, all you need to do is line it up with the pins on the back of the drive.

The LT switch looks like a wrench, and the 'wrench part' fits around the power plug. So once you set it there, you can see what point's you need to solder. Then just use a fiber glass scratch pen, or a knife and expose the point's you need to solder to.

[no1bladesfan]

Just wanna thank you guys on your replys...I have done the fix and is now working great. Had LT+ on my lite-on v7 and was getting the dirty disk error, now i have install LT+ 1.1 is working great. So thx to everyone who runs this site you do a great job here and cofree vids and advice helped me from pulling my hair out when loading my back up games