flashing benq drive read error.....help please!

[satry]

Has anyone had the following problem when trying to flash their BenQ:?

After you turn your 360 on and then off and then on again, it starts to read but gives the following error:
General failure writing to drive C.
Abort, retry, fail?

I am using a via sata 6421 pci card with updated drivers, iprep v006, usb bootable drive.

If anyone knows what the problem is and how to fix it, please let me know. Thanks in advance.

[CoFree]

try a different usb flash
you could try a floppy disc just to dump to see what that would do.
remember to wait for firmtool to run and build your hacked firmware.
if you use a floppy it will take a min or two for it to start.

make sure to check your key in firmware toolbox to make sure its good.

[satry]

Thanks so much .... switching the usb flash made it work.
Thanks again!!!