Problem when dumping firmware for BenQ Drive

[itln360]

When i try and dump the drive, the D1 always flashes when i power on the drive?? Here are the steps i am taking

(When promted to hit y to resend command)
1.(With drive powered off) hit Y then enter (Shows "Status: 0x7f")
2. Power on the drive (D1 will start flashing)
3. Power off the drive (D1 will stay solid) , wait 3 to 4 seconds
4. Power drive back on and D1 starts flashing again instead of dumping the banks???

Has anyone ever seen this before? any suggestions?

[CoFree]

this is a double post.
i answered the other one.