Xecuter LT Switch - Liteon 74850 83850 93450 Read Write Swit

[stutterman]

hi just found this


Xecuter has designed a simple switch for all the Liteon drives that enables firmware full read/write. They have also included an On/OFF Led to show correct operation when switching to 0x72 vendor mode.

The installation is very simple and takes about 60 seconds if you have some small experience with a soldering iron. It has been tested with the original DOSFLASH methods and also the new Jungle Flasher 0.1.69. All Liteon drive versions have been tested with 100% Success. There is no need to remove the LT Switch after it has been installed - simply switch to normal mode.

•Enables Read/Write on Liteon 74850, 83850, 93450 DVD Drives
•Easy Install
•Enable / Disable Switch
•On/Off LED
•No Need To Uninstall
•Works with all tools including latest Jungle Flasher
This product is for the legitimate retrieval of the DVD key so that it can be used on a replacement drive in the event of a faulty unit and out of warranty status. If you are intending to use this product for anything other than that do not buy this product.

EDIT COMMANDO

Nice bit off info there

Ive edited your post to show the image rigght. If you click edit on your post you will see how to insert an image.

[CoFree]

Sadalius or I will try to come up with one of these.
i would like to do some testing with this.

[cainhunpi]

wait. does that mean that we will be able to pull the key from the 9000 series without lifting the pin on the chip?

[CoFree]

that is my understanding

[Deathuntou]

That is a sweet find I will also get one soon, thanks for the post

[HaGGardSmurf]

Good stuff, how many points do you need to solder? I see 5.

Any idea on the price?

[djshauny1]

Looks pretty cool.
I wanna get me 1 of those

[Deathuntou]

I have read on a site in the UK that they only run around 4.99 special price right now that is UK currancy witch is around 11 dollars our money plus shipping cheap!

Good stuff, how many points do you need to solder? I see 5.

Any idea on the price?

[aN4rK1]

Sadalius or I will try to come up with one of these.
i would like to do some testing with this.

Let us know corfree, this looks interesting

[jetcat]

It´s a nice thing but you still need to do the cutting in the board.So you can use a resistor.kynar and a switch.