Help with my Benq

[mrinferno101]

so i run iprep just like the textbook tutorial. im using my flash drive and everything goes fine. i restart then when i get to detecting the drive...... then i get the 0x7f error. im using the recommended via chipset and watched the video on here and still the same error... please help!

[parminder]

hi it happened to me asswell just do this try using the port which is on the edge not the one the top so try it again and it should work. the port should be right and bit at the bottom. if this does not work try using different sata cable or different pci card or slot or drivers. make sure you chose via controller in iprep and ticked patch mtkflash.


Read the post created by me. it will be a huge help.

[CoFree]

so i run iprep just like the textbook tutorial. im using my flash drive and everything goes fine. i restart then when i get to detecting the drive...... then i get the 0x7f error. im using the recommended via chipset and watched the video on here and still the same error... please help!

well i take it the d1 is not flashing.
here are some things to try.
make sure you are on the sata port on the card that is closest to the front of the computer(inside the computer)
Chipset will not work.Most sata ports on the mobo will not work.
Try a different port on your sata card.The port closest to the front most of the time is the one to use.
Try a different sata card.This a card that is known to work
http://tekgems.com/Products/la-pci22-vt6421a.htm
Try a different sata cable
Put the sata card in a different pci slot
I would try this just for kicks before the next step.Try a floppy maybe that will do it (don't hold your breath)
You may even need to try a different computer.This is rare how ever it will happen some time.