benq v6038 reading error?

[JUVY]

hi...trying to flash a otha benq v6038 started it read it fine...read all banks o.k then at the end it gave me a error message...( datasum:7f3a insufficient diskspace error:file backups\1234567\89122\benq-cfw.bin does not exist ) dont know what this mean? flashed my other benq drive and went fine but this 1 am having problems with?

[CoFree]

what are you trying to dump the firmware on.

check the dump OFW in the backup folder.if its there check it with firmware toolbox and see if it a good dump.With a good key you may just need to build your CFW(hacked firmware)your self.

[JUVY]

were would the back up folder be located..? does it save to the floppy or sumthing that i use...? or u mean use the firmware tool and then wit that i can check the backup folder....

[MsK]

were would the back up folder be located..? does it save to the floppy or sumthing that i use...? or u mean use the firmware tool and then wit that i can check the backup folder....

yes it saves to the floppy or usb drive...

for floppy it should be here :

• a:\backups\1234567\89122\

navigate to it in FW Toolbox & check it 1st - you may have to re-dump it.

[MsK]

hi...trying to flash a otha benq v6038 started it read it fine...read all banks o.k then at the end it gave me a error message...( datasum:7f3a insufficient diskspace error:file backups\1234567\89122\benq-cfw.bin does not exist ) dont know what this mean? flashed my other benq drive and went fine but this 1 am having problems with?

were would the back up folder be located..? does it save to the floppy or sumthing that i use...? or u mean use the firmware tool and then wit that i can check the backup folder....

After reading the post properly it actually looks like your floppy disk is full!
Check the free space on the disk & if confirmed then re-format & prepare with iprep... then re-dump / then check with fw tool box / then if all good flash

[JUVY]

ok i didnt know that it saved it to the floppy...i used the same floopy i used wit my other benq that y it sayed that error message and not enough space...thanks for clering that up for me...gonna make a new floppy then try it again....thanks

[CoFree]

man if you are getting a error that means that you have a bad firmware key in the dvd drive right now.
If you trash the backup folder with your key in it .
you have just kill your chance of getting your drive to every work

you have to have a your good key.
all you can hope is its in the backup folder in the OFW.
if it is you will have to do a restore on the drive
that will be the only way to save it