Page 1 of 1
benq v6038 reading error?
Posted: Tue Apr 22, 2008 9:45 pm
by JUVY
hi...trying to flash a otha benq v6038 started it read it fine...read all banks o.k then at the end it gave me a error message...( datasum:7f3a insufficient diskspace error:file backups\1234567\89122\benq-cfw.bin does not exist ) dont know what this mean? flashed my other benq drive and went fine but this 1 am having problems with?
Re: benq v6038 reading error?
Posted: Tue Apr 22, 2008 10:02 pm
by CoFree
what are you trying to dump the firmware on.
check the dump OFW in the backup folder.if its there check it with firmware toolbox and see if it a good dump.With a good key you may just need to build your CFW(hacked firmware)your self.
Re: benq v6038 reading error?
Posted: Wed Apr 23, 2008 5:31 am
by JUVY
were would the back up folder be located..? does it save to the floppy or sumthing that i use...? or u mean use the firmware tool and then wit that i can check the backup folder....
Re: benq v6038 reading error?
Posted: Wed Apr 23, 2008 8:48 am
by MsK
JUVY wrote:were would the back up folder be located..? does it save to the floppy or sumthing that i use...? or u mean use the firmware tool and then wit that i can check the backup folder....
yes it saves to the floppy or usb drive...
for floppy it should be here :
- a:\backups\1234567\89122\
navigate to it in FW Toolbox & check it 1st - you may have to re-dump it.
Re: benq v6038 reading error?
Posted: Wed Apr 23, 2008 8:55 am
by MsK
JUVY wrote:hi...trying to flash a otha benq v6038 started it read it fine...read all banks o.k then at the end it gave me a error message...( datasum:7f3a insufficient diskspace error:file backups\1234567\89122\benq-cfw.bin does not exist ) dont know what this mean? flashed my other benq drive and went fine but this 1 am having problems with?
JUVY wrote:were would the back up folder be located..? does it save to the floppy or sumthing that i use...? or u mean use the firmware tool and then wit that i can check the backup folder....
After reading the post properly it actually looks like your floppy disk is full!
Check the free space on the disk & if confirmed then re-format & prepare with iprep... then re-dump / then check with fw tool box / then if all good flash
Re: benq v6038 reading error?
Posted: Wed Apr 23, 2008 6:43 pm
by JUVY
ok i didnt know that it saved it to the floppy...i used the same floopy i used wit my other benq that y it sayed that error message and not enough space...thanks for clering that up for me...gonna make a new floppy then try it again....thanks
Re: benq v6038 reading error?
Posted: Wed Apr 23, 2008 7:51 pm
by CoFree
man if you are getting a error that means that you have a bad firmware key in the dvd drive right now.
If you trash the backup folder with your key in it .
you have just kill your chance of getting your drive to every work
you have to have a your good key.
all you can hope is its in the backup folder in the OFW.
if it is you will have to do a restore on the drive
that will be the only way to save it