Robin Hoods Playground

Hi,

Im attempting to do my first Lite-On drive and I just want to clarify something. In order to flash the drive with the new Iprep 08.6, I need to Solder the points together on r707 and r708. I was going to just jump them with a wire soldered to each spot. Like this:

R707 X----wire----X
R708 x----wire----x

Sorry for the shady diagram but hopefully you see what I mean. Also, I read that I can leave them jumped after I read and flash the drive, is that correct?

all you have to solder is the 707tx point the flash is going to go in the sata cable.

Ok, so jump a wire across the R707 points, not the R708.

Can I leave this wire on after the drive is flashed?

you dont need to mess with te\he 708 rx point.
leave it alone.

as far as leaving the wire on.
im not sure
i leave mine on
but
i just got my probe in so i wont be soldering anymore.