Forgot to load Dump Files

[cyantific]

I read the key in the dvdkey32 tab inside JungleFlasher than clicked open dummy as source which shows the Key @ XXXX. I then opened the target firmware and clicked spoof to target and proceeded to flash. Not until later did I realize I had forgotten to load from dump files. Does the dummy.bin all ready contain those 3 files (key/inquiry/identify) and if not will the drive still read back-ups with a successful flash without them?

[CoFree]

you should be fine (i think)
those file are in the dummy file.
make sure to post back how it goes

[cyantific]

you should be fine (i think)
those file are in the dummy file.
make sure to post back how it goes

I eventually heard back from the guy and he said the drive was working fine. I compared his dummy.bin without having loading the Dump Files and saving the dummy.bin and then loading them and saving it again. They both show the key position so I believe on the dvdkey32 tab that once you hit Open Dummy as Source you don't need to load F/W Dump files on the first tab in Jungle Flasher. You can go right ahead and spoof to target.

[lilrevuk]

Yeah the dummy contains all those files... I read somewhere that using the dummy file is safer than using the 3 files to create your FW, but I tend to read a lot of tosh...