Jungle flashing a benq all the way ?

[pluto_00]

Heya peeps
I was wondering if I could flash / update a benq drive with only jungle flasher.

As I did my lite-on drive, and updated it now to ix 1.51 Using only jungleflasher.

The drive I had in mind of trying it on is already flashed I have a good key dump of the drive, but is still on the IX 1.4 CFW.


thnx

[Backslash]

Yeah man, when you're in it hit read, after getting it in vendor mode with either BenQ unlock or intro/device ID. It will read and then go to firmware tool tab and hit open target FW but it should auto-load if you choose. then hit spoof to target, or it will auto-load, and then save to file, and go back to MTKFlash tab and hit write, after verifying flash hit Outro/ ATA Reset

[pluto_00]

kk so it's about the same way doing a lite -on then, i'll try it out a bit later thnx !