Robin Hoods Playground

Heya peeps
I was wondering if I could flash / update a benq drive with only jungle flasher.

As I did my lite-on drive, and updated it now to ix 1.51 Using only jungleflasher.

The drive I had in mind of trying it on is already flashed I have a good key dump of the drive, but is still on the IX 1.4 CFW.


thnx

Yeah man, when you're in it hit read, after getting it in vendor mode with either BenQ unlock or intro/device ID. It will read and then go to firmware tool tab and hit open target FW but it should auto-load if you choose. then hit spoof to target, or it will auto-load, and then save to file, and go back to MTKFlash tab and hit write, after verifying flash hit Outro/ ATA Reset

kk so it's about the same way doing a lite -on then, i'll try it out a bit later thnx !