Fail Lite-on flash spoof to benq ASAP PLEASE

[xx0warrig0xx]

Ok it failed and is now dead. I have my friends benq i want to put in my driveless 360 (lite on briked) then we want to flash it. Please explain quickly ASAP

F* you microsoft

[CoFree]

Ok it failed and is now dead.

not sure what that is about.

I have my friends benq i want to put in my driveless 360 (lite on briked) then we want to flash it.

ok so you have a benq dvd drive and you want to put it in a console that had a lite-on dvd drive.

1. do you have the dummybin from the lite-on drive.

if so
this is the way i would do it.
others may/would do it different.

open jungle flasher
click open source firmware [ input the dummy.bin that came from the lite-on drive]
click open target firmware [input the ix v1.51 for the benq drive]
click spoof to target
after you see the key moved down.
click save to flie. save it as bencfw.bin

now
make a iprep boot flash
after that go into the backup folder and make 2 folder one in the other.
the first folder name 1234567 and the one in that or 2nd folder name 12345
in the 2nd folder put a copy of the bencfw.bin

now
boot on the iprep flash drive
when its booted up and running
type
fben 1234567 12345
then just do what it says on the screen.

make sure to have the other drives unplugged before you boot on the usb flash.

[xx0warrig0xx]

TYSM COFREE I FLASHED MY 360!!!

the only thing is that the benq takes longer to load then the lite-on and the pixel shading is a little off but its fine THANKS!

but for next time im going to buy a Benq or a ms28 as a backup so when i flash my friends liteon

[CoFree]

the pixel shading is a little off

not sure what you are saying man
i can never tell the difference in the picture on the screen

good job though man.

[xx0warrig0xx]

Pixil shading is the graphics mostly seen on hd tvs like mine when using a HDMI cable in 1080p. Im currently playing my COD 5 so ill get back to it l8r though thanks thourgh