I/O Port Help

Post by **TheLittleGuy** » Mon Jul 20, 2009 3:43 pm

Hey guys I've been looking for the answer for awhile and i couldnt find it so i decided to ask for help. Well i connect my xbox drive to my ck3 set and it ejects, but when i try to find out what I/O port its on because i wanna unbrick my liteon i go through jungleflasher and when i go to the I/O Ports it doesnt say i have any connected. Any ideas?

Post by **cainhunpi** » Mon Jul 20, 2009 4:43 pm

did you install portIO32?

Post by **TheLittleGuy** » Mon Jul 20, 2009 4:50 pm

Yes I did, has 1 hardware ID's: winford_io

Post by **Shootsteel** » Mon Jul 20, 2009 5:13 pm

you don't use JF to unbrick the drive....Dosflash is your key to success. Look in the drive flashing section of this forum. If you need more give a shout back.

Post by **TheLittleGuy** » Mon Jul 20, 2009 5:23 pm

Shootsteel wrote:you don't use JF to unbrick the drive....Dosflash is your key to success. Look in the drive flashing section of this forum. If you need more give a shout back.

no i know that but i was using CoFree's tutorial and in dos it says u have to enter your I/O port and i dont know which 1 it is and i was gonna use JF to fine what I/O port it was on.

Post by **TheLittleGuy** » Wed Jul 22, 2009 10:56 pm

figured it out thx tho guys

Robin Hoods Playground

I/O Port Help

I/O Port Help

Re: I/O Port Help

Re: I/O Port Help

Re: I/O Port Help

Re: I/O Port Help

Re: I/O Port Help