Page 1 of 1
I/O Port Help
Posted: Mon Jul 20, 2009 3:43 pm
by TheLittleGuy
Hey guys I've been looking for the answer for awhile and i couldnt find it so i decided to ask for help. Well i connect my xbox drive to my ck3 set and it ejects, but when i try to find out what I/O port its on because i wanna unbrick my liteon i go through jungleflasher and when i go to the I/O Ports it doesnt say i have any connected. Any ideas?
Re: I/O Port Help
Posted: Mon Jul 20, 2009 4:43 pm
by cainhunpi
did you install portIO32?
Re: I/O Port Help
Posted: Mon Jul 20, 2009 4:50 pm
by TheLittleGuy
Yes I did, has 1 hardware ID's: winford_io
Re: I/O Port Help
Posted: Mon Jul 20, 2009 5:13 pm
by Shootsteel
you don't use JF to unbrick the drive....Dosflash is your key to success. Look in the drive flashing section of this forum. If you need more give a shout back.
Re: I/O Port Help
Posted: Mon Jul 20, 2009 5:23 pm
by TheLittleGuy
Shootsteel wrote:you don't use JF to unbrick the drive....Dosflash is your key to success. Look in the drive flashing section of this forum. If you need more give a shout back.
no i know that but i was using CoFree's tutorial and in dos it says u have to enter your I/O port and i dont know which 1 it is and i was gonna use JF to fine what I/O port it was on.
Re: I/O Port Help
Posted: Wed Jul 22, 2009 10:56 pm
by TheLittleGuy
figured it out thx tho guys