Before i get started i'd like to apologize for any noobishness and i'd like to say Thank you in advance for any help given. I have a bit of a dilemma. I am trying to flash a benq for the first time. i first tried it with JF . Benq unlock gave me the "vendor intro failed" error. Then i tried the hitting the intro button and pulling the power within a second trick. No dice......Then i tried iprep 8.9.
I got as far as loading the updated benq software on to my usb then. I wasn't able to boot as FAT so I tried FAT32 and that worked. I was able to boot off the usb drive.
Then i got as far as the section where you type in the serial #. Did that. Then I hit any key to continue. And nothing......I get the first line of info " BOOTFLASH 1.7 Databuild ect., ect." But only that first line and then it locks up. I have to do a hard shut down on pc to get it to do anything after that. Pulling my hair out. Please help.
Thanks again...
BENQ flashing problems
Re: BENQ flashing problems
hi there its been a while since i did a benq but they are quite easy realy using iprep and a bootable usb,
but have a look at this post of mine it might get you going (dont worry about the blaster mentioned its nothing)
viewtopic.php?f=63&t=920#p5655" onclick="window.open(this.href);return false;
but have a look at this post of mine it might get you going (dont worry about the blaster mentioned its nothing)
viewtopic.php?f=63&t=920#p5655" onclick="window.open(this.href);return false;
a flashing frenzy huh huh
