iprep ms25 HELP!!!

[killingtime]

just started the flash process with samsung ms25 using iprep 10.7 and tutorial , i get to frst part when i power on 360 it says an internal stack overflow has caused this sesion to halt,Change the stacks setting in youy config.sys" what do i do now ?

[commando_lee]

go into your bios and disable your flopppy drive, even if you dont have 1 go into there and disable the floopy drives

[killingtime]

can u keep eye for my messages m8 to help us out thx and apreciate fast reply

[killingtime]

pc has no floppy , should i disable dvd drive ?

[commando_lee]

even tho it doesnt have one. go into bios and disable it in bios, that normaly sorts that problem out

[killingtime]

i disable it but still same thing coming up

[commando_lee]

when you have shut down, un plug all hdd and dvd drives and try again

[killingtime]

all drives disabled and i still get the same thing coming up , what can it be now ? and i appreciate the fast replies and help

[commando_lee]

not sure then that normaly sorts it, wait for some 1 else to put some ideas this way

[killingtime]

could it be the driver i installed with the via sata card ?

[commando_lee]

try iprep 9 from the download section, see what happens with that

[killingtime]

right i sorted tht proble i changed sata ports , now im upto mtk vendor mode and where he says power of to get it into vendor which is my best way as im powering it through xbox ?

[commando_lee]

pull the power cord out, plug bk in and turn 360 back on quickly tho, make sure you have the av cable in it as well

[killingtime]

now when i power on the original problem comes back , its strange

[killingtime]

my status before i switch off is 0xFF is this right cause i cant get any further than this point ?