Liteon 74850C flash help plz....tried everything.

[hyperice]

Can someone PLEASE PLEASE help me...i cannot get my Liteon 74850C drive to flash for the life on me..

I have

-Via 6421 Raid Controller... (plugged in/installed/operational)
-iprep 10.7
-Xtractor Pro w/probe

so i've made the boot with iprep to boot to my usb...boot into iprep.

follow the instructions, turn everything on, turn off, halfway tray, turn back on

put probe on the R707, hit enter..and I either get

-Unknown Liteon Firmware-
or
-can't dump inquiry-

any suggestions??

my primary port DF00; that Iprep chooses for my via6421

with Jungleflasher;

-newest version of jungle flasher

so i do what everyone one says, desable the sata board, erase the driver, enable sata board, reboot..install the USb Driver( does it matter if its Xtractor USB? or Ck3 Usb Driver?)
install the portIO32..

go into jungleflasher, and find the port.

only problem is; my sata board comes up, but not my drive..(DRIVE IS UNDECTED)..tried in the xtractor reader as well,,

i'm plugging my xtrator in with the USB, instead on a serial..and there was a time it would go to in jungleflasher COM 3, usb!! but haven't been able to get that again, the xtractor registered as a new device my first time i did it, not since again...

tried serial cable with NO luck...

any suggestions? PLEASE....I'm going to throw this stupid liteon in the trash pretty freaking quick...

[gazzer]

when you treid with iprep 10.7 do you make sure your rs cable isnt connected dont need that with liteon with 10.7 version

[stevio1973]

Are you sorted yet mate?

[djshauny1]

If you have msn messenger pm me with your details and ill support you through that mate

DJ