Connectivity kits cable connection

[dalecheesy]

Just a short one which may save you frying your drive.

When connecting the dvd lead please make sure to align the raised splines on the plug into the notches in the drive as if it's plugged in upside down there is a high probability of burning your ck3/drive out.

[conan281]

Thank you for your help man

[stealthdf2]

i agree thanks for pointing it out. Sometimes i will even go as far as putting a dot on one side of the plug with a magic marker just to make sure i dont screw up .

[ohnoacucumber]

Thanks this helps alot I was worried about this, nice diagram btw.

-cucumber

[rkd2398]

This might be the place to ask this, but with the CK3 and Probe, you get one green power cable and then the blue cable with probe. Do you have to switch the cables out when flashing different drives? Or can I always use the blue cable with the probe?

Thanks!!

[CoFree]

yea
it would have been better to start your own thread
but its all good man
no big deal.

no you dont have to i use the power that has the probe on it to do them all.
i just dont want to take it on and off.

[he-man]

i agree thanks for pointing it out. Sometimes i will even go as far as putting a dot on one side of the plug with a magic marker just to make sure i dont screw up .

Great minds think alike and fools never differ I did the same just to be safe!

[julio1583]

Too late for me... Burned my CK3. Just baought me new one. Defenetly mark the top!. Hehe