Yeah i didnt back up the frw, the device that had the orign.bin has been formatted severly times, in an attempt to fix the issue. this is the steps i had takenMsK wrote:
ok.. it doesn't sound good
as sadalius & cofree have stated tho.. the 10sec trick is the common method for bypassing the firmguard
(although not for me! I have to use the enable disc // maybe it's something to do with my sata card)
I just read this thread from start to finish & some details are missing.
Can we go back over a few details so I can understand where you went wrong & try to decipher if there is a solution.
1st of all.... you say you didn't backup your original firmware! but.. what about the flash key you used.. has that since been formatted or is it still intact from your failed attempt?
1. define drive (samsung ms28)
2. dload fw (xbin53)
3. format flashdrive make bootable (XBM)
4. boot into flash drive (with PCI SATA card connected)
5. connect xbox to sata card
6. xRead along with serial (turn off xbox, press 3 wait 10sec and turn xbox on)
7. xFlash along with serial (do 10sec trick again)