I need help!!! Ready to flash!

[CoFree]

for sure man that could be geekin iprep out.

[Freebeer187]

No go I unhooked the hdd and still got the 0x7F to 0x80 but no debug. I wonder if its being blocked? Have you done it to an arcade system?

[CoFree]

yep

the computer is not seeing the 360 drive.
That is what i think

[Freebeer187]

Maby updated drivers?

Or possibly something in the bios?

[Freebeer187]

Hey in ur iprep 006 tut, you show VT6421. Thats the same one that i have but you say that you do not use my same card...

[CoFree]

the card is a rosewill rc-212. it has 4 sata ports 2 inside and 2 outside and a ide controller

as far as it having the same info show up man i dont know.

[Freebeer187]

Hey i never pressed the "switch to IDE Based controllers" button and this is what i got on my pc. What do u think? I think the one that is all green is my hdd conenction. SHould i try it?




The first one to the top is the one that is all green

[CoFree]

thats the different controllers that you have in your computer.you could try a different one
you have to make sure that the port you input is for sure the one your 360 is hooked to.it will not work if its in the wrong plug

be careful man don't mess up one of your drives by formatting it with iprep

[Freebeer187]

Well the only drive that is using sata is my HDD. I could just remove the cable from the hdd put it to the 360. Think its compatable?

[CoFree]

if your mobo has a via or nforce chipset it may work

[Freebeer187]

i dunno man i doubt it. This is my pc:

http://support.gateway.com/s/PC/R/3724/4367sp3.shtml

[CoFree]

man i dont know

its just no this hard something is messing it up somehow

[Freebeer187]

I got the D1 to come up with my sata connection from my mobo. Only after u turn it off for the 2 seconds and turn it back it will go back to the d1 and 51 and not read... I think i need a new card.

[CoFree]

i think so man. you are close .

[Freebeer187]

Well im going to take a break on it. It has to be the card so im going to purchase a new one